Necktie Eyeglass Case
Spoiler alert: If you are a dad in my family, look away!
While reading my magazines in the bath the other day (yes, ahhh...it was wonderful, a rare occasion), I came across a cute Father's Day gift idea in the June Country Living (page 48). It read, "Transform a traditional necktie into nifty eyeglass case for dear old Dad. So off to the thrift store I went....
I think I over paid for my ties, but they were there and I was there and well, frankly, with three kids, sometimes that's as good as it's gonna get.
First step is to cut the tie 17 inches from the point.
The inside of the tie is where the glasses will be held. Only one of my ties needed a quick seem ripper action down the middle.
Of course this ended up opening up the entire thing so I needed to glue it back together.
"Sewing with a tube"...how much better can it get?
I used glue on another tie that had a flap where eyeglass frames would probably get caught.
My third tie had a cushiony filler that also needed a little glue.
After patching up the loose areas, fold the length of the tie over the back, tucking in the very end about an inch for a finished look. One of my ties that had the cushiony filler needed the inside cut out about one inch from the end to keep it from getting too thick when folded.
Whip stitch along the top and sides, being careful not to sew the pouch closed.
Attach velcro to the tips and coordinating area when closed. I used the softer side of the velcro where the eyeglasses would slide in to avoid scratches.
Unfortunately when gluing one of the ties, some of the glue bled through the fabric resulting in a couple small stains on the front. Soooo......
linking to the following party: